
Re: How to debug a directpath problem
Thanks for the reply,
I currently have
ONE: 1 x PCI dual dvt-t card (working 100%)
TWO: 1 x PCI dvb-s2 card (was almost working, could see signal quality but no stations found until i installed the card below, now i dont get any signal)
THREE: 1 x PCI-Express Dual dvb-s and Dual dvb-t card.
The PCI bus is shared, so all slots must be used by 1 VM (i think).
I cannot see anything in any log (which I have attached).
I have tried using the d0d3 reset for the 2nd card and also the IOAPIC mode. But nothing seems to work.
When I get a bit more time, im going to try the following
1. windows xp (seems to be less fussy from what ive read than win7)
2. Trying 1 device at a time.
Do I need to restart esxi when i change the reset mode?
cheers