temp.vm-help.com
http://www.vm-help.com/forum/

PowerEdge 750 with cerc
http://www.vm-help.com/forum/viewtopic.php?f=4&t=3086
Page 1 of 1

Author:  sp_nl [ Fri Jun 10, 2011 4:00 am ]
Post subject:  PowerEdge 750 with cerc

I get the ESXi installed up and running but when i write an image to the system using the standalone converted the raid volume fails
the server start a peeping noise and log say raid fails

When i reboot rebuild the raid array reinstall it looks good but after i use the converto to get my image on it starts again

Used a other Poweredge 750 with same config CERC with two drive
same problem

So i remove the cerc card and wanted to use onboard SATA controller
I see the drive in the bios i can install windows XP on it but Exsi say no drives found

What is the next step to try??

Author:  Dave.Mishchenko [ Sat Jun 11, 2011 10:07 pm ]
Post subject:  Re: PowerEdge 750 with cerc

During the install access the console by pressing ALT+F1. Login with root (no password). Do you see the disks if you run fdisk -l? If so you might have to use an IDE install hack. Otherwise you may have a driver issue. In that case can you post the model and PCI id for the controller? http://www.vm-help.com/esx40i/find_PCI_ID.php

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/