Hi
I am having difficulties trying to install ESXi 4.1 on a Dell PowerEdge 800 Server.

I created an RAID-1 array, using the embedded CERC SATA1.5/6ch (Since the Promise TX2650 isn't supported(not in the HCL List)).

Well, when i start the installation, it does not detect my array. It detects two hdds , but not my array. On the HCL list, i can see that this controller is supported.

What could i do in order to get it installed ? Is there any option i shoud select, or any command ?

Creating the array again, but now zerofilling the hdds, would make any difference ?

Thanks in advance
Pablo.